Changes between Version 30 and Version 31 of DetailedInstall

Timestamp:

Jun 24, 2008, 5:46:29 AM (16 years ago)

Author:

IgorL

Comment:

--

DetailedInstall

@@ -439 +439 @@
     * Proceed to '''Plugins -> Ray Suite -> open a widget -> click "Register"''' - you should perform this for every widget.
         
-    * In case you're going to use RMS (Ray Media Server), proceed to '''Base Settings''' and specify the IP or domain address of your RMS, the ports it's going to use (usually 1935 and 5080) and tick the '''Use RMS''' checkbox.
-
-    If you have installed Free package, you can use !BoonEx RMS. In this case you only have to tick the '''Use RMS''' checkbox without changing the other settings in this window.
-
-    Click '''Save -> OK''' and close the Ray Suite window.
-        
+    * In case you're going to use RMS (Ray Media Server), proceed to the '''Base Settings''', check '''Use RMS''', specify '''RMS Address''' (the IP address of your RMS), '''RMS Port''' ('''1935''' by default) and '''RMS HTTP Port''' ('''5080''' by default).
+        
+    Click '''Save -> OK'''. If you see no error notification, your RMS is running properly. If the notification '''Can't connect to RMS''' appears, refer to this [http://www.boonex.com/trac/ray/wiki/GenRayTshooter#MyRMSwidgetsChatIMVideoRecorderendupinConnecting.WhatshouldIdo Troubleshooter]
+
+    '''Note''': If you have installed the Free package, you can use !BoonEx RMS rather than install your own one. In this case you have to navigate to '''Base Settings''', tick the '''Use RMS''' checkbox and specify the following values: '''rms.boonex.com''' for '''RMS Address''', '''10000''' for '''RMS Port''' and '''10080''' for '''RMS HTTP Port'''. Click '''Save -> OK'''. If the notification '''Can't connect to RMS''' appears, report this problem to '''support@boonex.com'''
+
     * Proceed to to '''Plugins -> Orca'''