RMS for Ray 3.1 Vs RMS for Ray 3.0
Dotnet
posted 11th of February 2008
in
Community Voice.
4 comments.
To Victor T,Greetings.
I would like to know whether RMS for Ray 3.1 is different from RMS for Ray 3.0.
I have gotten a RMS with Ray 3.0 running very well on my server and I would like to upgrade my site from 6.0003 to 6.0004 with Ray 3.1.
I don’t wanna stress myself out once again with RMS installation since I know it is very tricky and can give somebody a serious headache. I will appreciate to keep my actual RMS. I failed to install it myself. So I had to hire an Expertzzz.
Can Ray 3.1 run with a RMS used for Ray 3.0? Are there any cons?
In case of differences, please tell me how to upgrade my RMS.
I cross my fingers hoping you won’t tell me that a Fresh RMS Install is required. Please do not give me a heart attack.
Thanks.
Dotnet
Below is the legacy version of the Boonex site, maintained for Dolphin.Pro 7.x support.
The new Dolphin solution is powered by UNA Community Management System.
The new Dolphin solution is powered by UNA Community Management System.
I will stop at that, so I am not the one responsible for the Heart Attack! :-)
But the answer is yes. You will have to upgrade to the newest one. In other words it is not upgrade but the new fresh installation of RMS.
RMS installation instructions are located here http://www.boonex.com/trac/ray/wiki/RayServerInstall
The installation is not so compliacted. Of course, this requires some skills in using SSH and command line.
Please let me know if the instructions or part of them are not clear enough see more
I just wanted to make my life a little bit easier. The new RMS installation is done. Once again I've ordered it from an Expertzzz.
Dotnet
i test rms 3.51 with dolphin, there is no restriction of ports but i am unable to connect.
pls advice.
Thanks